WireTech 5000P-10x, User Manual

Page: 12 / 28

only valid when the output smoothing is configured as Fixed Rate.
5.2 Outputs Menu
Under Outputs Menu, you can monitor and configure the parameters of the CI, AV
decoder, ASI out, ASI2/SDI out, Mux (A), BISS, SDI out and TS over IP output (B).
Note: (A) The Mux menu is showed only if the functional block is enabled. Refer to section
5.3.6.
(B) The Ethernet menu is showed only if the unit is a Megabit model, on which IP
streaming in/out board is installed and the TS/IP streaming
board is set to “IP Out”.
Refer to section 5.3.6.
5.2.1 BISS Menu
It includes Biss Mode, Biss 1 Setup and Biss E Setup
Biss Mode
：
Set Biss mode, can select OFF, Biss E or Biss 1
Biss 1 Setup
：
set Biss 1, password is required
Biss E Setup
：
set Biss E, ID number and password are required
5.2.2 CI Menu
There are two PCMCIA slots for inserting CAM for de-encrypting program from the input
signal.
Before setting CI, ensure the signal from ASI input is locked or the Tuner locks on the
correct Transponder (this depends on in which signal the encrypted program carried). The
„Tuner Lock‟ LED will 'on' in green.
There are 3 submenus:
„CI Source‟, „Setup‟ and „CAM name‟ which allow you to set or
select the parameters of the CI.
CI Source: press the <ENTER>-key, then use < > or < >-key select Tuner or ASI1
input or ASI2 input or
TS/IP input (only when the TS/IP is set “IP In”, refer section 5.2.7
for details) to set the signal source of descrambling, press <ENTER>-key to save or
Outputs
BISS CI Decoder ASI1 ASI2 Ethernet
Mux
SDI