10
WPS-550-DOM-A Installation Manual
3. Fine-Tuning Camera Adjustments
The camera is supplied with a OSD Joystick / BNC Test Adapter that
allows for viewing the output of the camera on a monitor or the WPS-
CCTV-TESTER (not included). Use this connection to adjust the camera
directly from the installed location.
A. Connect the OSD Joystick / BNC
Test Adapter Connection to a
monitor or WPS-CCTV-TESTER video
in.
B. Connect a 12V DC Power Supply to
the Secondary Power connection
on the OSD Joystick / BNC Test
Adapter if no other power
connection is active.
Warning!! The Test Port adapter
power connection for this camera
only uses a 12 V DC power supply.
Using a 24 V AC or other voltage
power supply with the Test Port
Adapter will result in damage to the
camera, and possibly the power
supply.
C. Adjust the camera’s 3-axis angle so the lens points in the desired
direction. The lens angle should not exceed 50˚ off the center axis.
D. Loosen, but do not remove the zoom and focus set screws on the lens.
E. Rotate the lens until you achieve the desired setting.
F. Once the Zoom and Focus are adjusted, disconnect the WPS-CCTV-
TESTER or Monitor, and power supply from the Local Test Connections.
G. Configure the camera using the OSD as defined in the Set-Up Section.
Adjust Zoom
Adjust Focus
OSD Joystick / BNC Test Adapter
Connection
