SERVICE MANUAL & ICA
WIPLINE 2100 & 2350 FLOATS
Page 56
Revision N
P/N 1002549
Level aircraft per manufacturer’s instructions in Maintenance Manual TC10000AMM for CC-18 or XC10000AMM
for CC-19.
Place scales under the right and left main and nose gears.
Place blocking under the right and left main gears to level aircraft.
Drop plumb bob from the wing leading edge and mark the floor parallel to the aircraft leading edge. Measure 60.0
inches forward of the leading edge line and mark a line. This 2nd line is the datum, 0.0.
Measure the distance from 0.0 to each nose wheel center. This is X1 and X2.
Measure the distance from 0.0 to each main wheel center. This is Y1 and Y2.
Use this table for the calculations:
11.2 WEIGHING PROCEDURES FOR CUB CRAFTERS CC-18 AND CC-19
FLOATPLANE
Totals
Notes:
1. Zero out or deduct tare weights at the Y arms.
2. If using an overhead hoist and load cell, pick up aircraft at the center line of the front spar wing butt fittings.
The center line of the front spar is +9 inches from the wing leading edge.
3. Level the aircraft by placing weight on the float deck where it is needed. Record the tare weight and arm.
