Wintriss autoset 1500, User Manual

Page: 29 / 102

AutoSet User Manual 1137200
Installation 2-9
To connect a wire, loosen the screw over the correct slot by turning it counterclockwise
(see Figure 2-7). Strip the wire 1/4” (6.4 mm) from the end. Insert the bare wire into the
slot 90% of the way. Tighten the screw. The metal tooth inside the slot will clamp down
on the bare wire for a tight connection. Make sure the metal tooth is clamped down on the
bare part of the wire, not on the insulation. If it is on the insulation, you will have a bad
connection.
7.
Connect the press control stop circuit wires to the TB103 connector, as shown in
Table 2-1. Either wire can be connected to either pin.
8.
Plug the connector back into the TB103 terminal block. Double-check connections,
referring to the labels stamped on the board.
9.
Make all necessary conduit connections to ensure NEMA 12 protection.
10.
Do not connect wires to the AC power source until you are done with all other installation
procedures. Also, make sure you number all wires in a way consistent with your press’s
electrical prints.
A ground wire is attached from pin #4 on the TB103 connector to a case lug, as shown in
Figure 2-6. It is recommended that you not remove this wire while making connections,
but if you do, make sure to reconnect it when you are done.
Figure 2-7. Correct Way To Make Terminal Block Connections
The TB103 connector can only plug in one way. Make sure you do not start at the wrong
end when connecting AC or stop circuit wires. Check your wiring against the labels
stamped on the processor board, holding the connector against the terminal block the way
it plugs in.
ELECTRIC SHOCK HAZARD
Do not connect AC wires to the power source until all other installation procedures have
been completed.
Failure to comply with these instructions could result in death or serious injury.
NOTICE
Insert wire here
Tighten screw to clamp
wire in terminal
NOTICE
WARNING
!