Operation
26
9.3.5
Terminating the washing programme
A washing programme can be terminated in the following ways:
Press the start button
Press the quick start button
Tap on the button of the selected washing programme
9.3.6
Tank water exchange programme
If the tank water is very dirty due to excessive intake of soiled material and this impairs the end wash result,
the tank water can be replaced, in whole or in part.
INFO
As a default, the 3 stages for replacement are defined as follows: 30 %, 50 % and 100 %. At your
request, the service technician can, however, change these 3 stages.
Start programme
Press button (1).
Press one of the 3 buttons (2).
INFO
The time specified above the buttons refers to the
duration required until the machine is ready for
operation. This depends on approximate details, which,
in turn, are contingent on local circumstances (e.g. inlet
water temperature).
Tank is (partially) emptied.
The start button gradually changes colour from blue to not lit.
Machine is refilled.
The start button gradually changes colour from red to green.
The machine is then ready for use again.
9.3.7
Wash breaks
Do not switch the machine off during wash breaks.
Close the door to prevent any cooling down.
9.4 Switch off the machine
Switch the machine off at the end of the working day using the self-cleaning programme (
10.1.1) so that it
is cleaned and emptied every day.
INFO
If you use the On/Off button, the tank stays filled but will no longer be kept at temperature. If the
tank temperature has dropped too much before the machine is switched on again, the machine will
be emptied and refilled automatically.
