![background image](http://html1.mh-extra.com/html/winnebago/suncruiser-33v/suncruiser-33v_operators-manual_987514087.webp)
8-3
SECTION 8
ENTERTAINMENT
8 ENTER
T
A
INMENT
Operation
Raising Antenna
Turn elevating crank clockwise in “UP”
direction until some resistance to turning is
noted. Antenna is now in operating position.
Turn amplifier power switch “ON” to receive TV
signal.
Rotating Antenna
Make sure antenna is in the “UP” position.
Pull down on directional handle until it
disengages ceiling plate and rotate for best
picture and sound on TV set.
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional
handle aligns with pointer on ceiling plate.
Turn elevating crank (counterclockwise) in
“DOWN” direction until resistance is noted.
Antenna is now locked in travel position. Turn
amplifier power switch “OFF”.
TV Signal Amplifier
The amplifier power switch is located on the
video selection system panel in the video center
cabinet above the driver and passenger seats or
entertainment center cabinet.
To operate the amplifier, turn on the power
switch. A red indicator light will glow while the
signal amplifier is in use.
Checking Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the
transmitter. Signals may vary from strong to no
usable signal at all. We recommend that the TV
system be checked out in an area known to have
good TV reception.
To check the antenna amplifier, raise the
antenna, select a TV channel and rotate the
antenna for best picture. Then turn off the
amplifier power switch. If the antenna amplifier
is working properly, the TV picture will now be
degraded (snowy). When you turn the switch
back on, the picture should again be sharp.
Antenna Check Light
The antenna check light will come on for 20
seconds when the ignition switch is turned on to
remind you to be sure the TV antenna and/or
satellite dish are lowered completely into the roof
cradle for travel storage.
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
CAUTION
Always align directional handle to
“DOWN” position before lowering.