SECTION 7
PLUMBING
7-14
12. Press the ON/OFF button (OUT). Finished!
13. Go back to step 9 of ‘Blow-Out Procedure’.
To use again:
Flush the water pipes, then
1. Reconnect the water inlet hoses to the
corresponding HOT/COLD faucets. Turn the
faucets ON. (NOTE: Check the water inlet
hoses and pump periodically. Refer to the
“Use & Care Guide” that came with the
machine)
2. Plug the washer-dryer into an appropriate
electrical outlet (or reconnect power supply)
3. With the ON/OFF button in the off (OUT)
position, pour 1/2 TBSP. of powder detergent
(or liquid equiv.) into the ‘Detergent’
compartment inside the Dispenser Drawer
4. Advance the Program Selector knob to an
EXPRESS cycle
5. Press the ON/OFF button (IN) and allow the
machine to run through the complete cycle to
clean out any remaining antifreeze. Finished!
WATER SYSTEM DRAIN VALVE LOCATIONS
SYSTEM
DRAIN VALVE LOCATIONS
Water Lines:
Valves in the utility compartment on the passenger side of the
coach, behind the main entrance door.
Open exterior shower faucet and lay shower head on ground.
Also, to drain any water left in the city water line, place the tip of
your finger inside the city water connection and gently press the
backflow valve (small “button” in center of connector).
Water Tank:
One (1) valve near the water tank in the utility compartment on
the passenger side of the coach.
Water Heater:
Drain plug on outside of coach, behind service door. Use socket
to remove drain plug.
Water Heater Bypass Valve:
Bypass valve is located in the utility compartment on the passen-
ger side of the coach.
Winterization (Antifreeze) Valve:
Valve with clear vinyl siphon tube is located in the utility com-
partment on the passenger side of the coach.
