SECTION 4
APPLIANCES & SYSTEMS
4-6
To Open the Door During a Wash Cycle:
Follow these steps if you need to open the
door to your washer-dryer after a cycle has
already begun.
1. Advance the Program Selector to 'Reset' and
wait 5 seconds.
2. Advance the Program Selector to 'Drain' (8
o'clock') and allow the machine to drain
completely.
3. Advance the Program selector to 'Reset' (the
'Status/Door Lock' LED will blink quickly to
indicate that the cycle has stopped, but the
door is STILL LOCKED)
4. When the 'Status/Door Lock' LED blinks
SLOWLY (takes 1-2 minutes), you can open
the door.
To Open During a Dry Cycle:
1. Advance the Program selector to 'Reset' (the
'Status/Door Lock' LED will blink quickly to
indicate that the cycle has stopped, but the
door is STILL LOCKED)
2. When the 'Status/Door Lock' LED blinks
SLOWLY (takes 1-2 minutes), you can open
the door.
IMPORTANT! Once a wash cycle is
underway, the washer-dryer door will LOCK for
the duration of the cycle and will STAY LOCKED
for up to 2 minutes after the cycle ends. DO NOT
attempt to open the door unless the 'STATUS/
DOOR LOCK' LED is BLINKING SLOWLY!
Water Supply Faucets
The washing machine water supply faucets
are located inside the cabinet door above the
machine. Always turn supply faucets off when
not using washing machine to avoid possible
water leaks if a hose or hose gasket should fail.
See Winterization Procedure in section 7
Plumbing.
LP GAS FURNACE
To Start Up:
1. Open the LP gas tank valve by turning fully
counterclockwise.
2. Move thermostat switch from OFF to GAS
HEAT and press the Temp Selector button
(Up/Down arrows) until the desired
temperature is shown on the display.
3. Furnace fan will start to blow soon after
setting thermostat.
4. After about 30 seconds, the furnace burner
will light.
5. The furnace will now cycle off and on
automatically as the thermostat demands just
like a household furnace.
NOTE: If heat does not come out of the heat
ducts after a minute or so the burner is
not lit. Turn thermostat off for 3-5
minutes, check to be sure tank valve is
open and tank is not out of fuel, then try
Water Supply Faucets
-typical
