![background image](http://html1.mh-extra.com/html/winnebago/suncruiser-33v/suncruiser-33v_operators-manual_987514048.webp)
SECTION 4
APPLIANCES & SYSTEMS
4-8
Air Conditioner/ Heat Pump Filter
The disposable furnace type filter must be
inspected and replaced periodically so the air
conditioner will operate efficiently.
•
Be sure ceiling vents are open to distribute
heat pump output air. Also make sure
furniture, clothing items, packages or other
obstructions do not block the return air grilles
beneath the rear bed.
•
The filter should be checked monthly for dirt
build-up and replaced as needed. The air filter
is a disposable woven fiberglass type, which
cannot be cleaned and should be replaced
when coated with dust.
Beneath Bed
Lift mattress board as shown above. A finger
hole is provided near the middle of the panel for
lift-out removal.
A/C Filter Size:
14” x 20” x 1”
14” x 20” x 1” & 10” x 20” x 1” (33V)
NOTE: Do not block the filter in any way, such
as by setting packages or newspapers,
etc. in front of the bed base grate. There
must be free air flow for the air
conditioner to operate efficiently.
Condenser Coils
The condenser is located behind the louvered
body panel on the right side of the coach. The
condenser is the large, black, rectangular area
that looks like a car radiator. The panel is hinged
at the top edge to allow opening for periodic
cleaning or service. Remove the screws under the
lower edge of the panel and swing it upward for
access to the condenser.
Periodically sweep debris carefully from the
fins of the condenser. Rinse dust off with clean
water. The condenser coils must be clean and free
of dust, debris and insect particles, etc., for the air
conditioner to cool efficiently.
Further Information
See the air conditioner manufacturer’s
operating instructions supplied in your Owner
InfoCase for detailed operating instructions,
special precautions, and basic troubleshooting.
CENTRAL HEAT/AIR
CONDITIONING SYSTEM
Electronic Thermostat
The thermostat controls heating, air
conditioning, cooling fan and heat pump
operation.
NOTE:The thermostat does not automatically
switch between heating and cooling. You
must place the thermostat switch in the
desired position.
Heat Source Switch
ELECTRIC = Heat Pump
GAS = Furnace
Temperature Selector
True Air Thermostat