7-17
SECTION 7
PLUMBING
3. Let the ice maker run through a cycle, then
raise the shut-off arm.
4. Be sure water has drained from ice maker
supply line, then reconnect to inlet valve.
5. Ice maker is now winterized.
6. Go back to Blow-Out Procedure Step 9.
To use Ice Maker again:
Flush antifreeze from the water lines, then
1. Close all drain valves.
2. Turn the water supply on.
3. Be sure the ice bin is in place and the
automatic shutoff arm is down.
4. Let the refrigerator cool down to ice making
temperature. Remember, this can take up to 24
hours.
5. Let the ice maker cycle and dump the first
batch of ice.
Winterizing Washer-Dryer
Method 1–
Draining Water
Follow these steps to winterize (drain) your
washer-dryer for freezing temperatures.
1. With the machine power OFF, pour 1/2 quart
of RV-type antifreeze into the washer drum
2. Close the door. Advance the Program Selector
knob to a SPIN position
3. Press ON/OFF Button (IN). Wait 1-2 minutes
4. Press ON/OFF Button (OUT). Unplug the
washer-dryer from the electrical outlet (or
disconnect power)
5. Turn the water supply faucets OFF.
Disconnect the inlet hoses from the faucets.
Drain any remaining water from the hoses.
6. Washer/Dryer is now winterized.
7. Go back to step 9 of ‘Blow-Out Procedure’.
Method 2–
Adding RV Antifreeze
If you’re currently pumping RV antifreeze
through the fresh water system, follow these
steps to winterize:
1. With the machine power OFF, turn the WASH
TEMP knob to HOT
2. Advance the Program Selector knob to
REGULAR in Cotton Heavy Duty
3. Press the ON/OFF button (IN) and let the
machine fill until antifreeze is in the drum
4. Advance Program Selector to a RESET. Wait
5 seconds (Status/Door Lock LED will blink)
5. Advance Program Selector to a SPIN
position. Let the antifreeze drain from the
drum
6. Advance Program Selector to RESET. Wait 5
seconds (Status/Door Lock LED will blink)
7. Turn the WASH TEMP knob to COLD
8. Advance the Program Selector knob to
REGULAR in Cotton Heavy Duty
9. Let the machine fill until you see antifreeze in
the drum
10. Advance the Program Selector knob to
RESET. Wait 5 seconds (Status/Door Lock
LED will blink)
11. Advance the Program Selector knob to SPIN.
Let the antifreeze drain from the drum
12. Press the ON/OFF button (OUT).
13. Washer/Dryer is now winterized.
14. Go back to step 9 of ‘Blow-Out Procedure’.
To use washer-dryer again:
Flush antifreeze from the water lines, then
1. Reconnect the water inlet hoses to the
corresponding HOT/COLD faucets. Turn the
faucets ON. (NOTE: Check the water inlet
Ice Maker Water Supply Connection
