![background image](http://html1.mh-extra.com/html/winnebago/horizon-40fd/horizon-40fd_manual_987486130.webp)
SECTION 11
MAINTENANCE & STORAGE
11-4
•
Never use aromatic solvents such as acetone,
MEK, toluene, xylene, lacquer thinner, etc.,
on appliques or decals. Any solvent including
alcohol may soften or smear colors.
•
Fuel or antifreeze spilled on appliques or
decals should be rinsed off immediately with
water.
FRONT END MASKS AND
PAINT DAMAGE
NOTE: This information is to make you aware of
a potential paint failure that could occur
when moisture is trapped between front
end masks and painted surfaces.
If you choose to install an aftermarket
protective front end mask, please follow these
preventive guidelines:
•
The front end mask must be removed if the
vehicle sits longer than 5 days without being
driven.
•
The front end mask must be thoroughly dry
before storing away or reinstalling on the front
of the coach.
•
When reinstalling the mask, be sure both the
mask and the painted surface are free of debris
to avoid damage by abrasion.
•
Failure to follow recommendations will void
any paint warranty.
HEADLIGHTS AND EXTERIOR
LIGHTS
Exterior Light Lenses
Most Winnebago Industries vehicles have
polycarbonate lenses on exterior lamps, which
are very sensitive to a variety of chemical
solvents and cleaners.
Use only soap and water to clean exterior
lamp lenses- especially headlights!
•
Contact with certain chemicals can cause
etching, ‘crazing’ or cracking of the lens,
which can significantly reduce the lens clarity
and effectiveness of the lamp and may require
replacement of the complete lamp housing.
•
Some popular citric acid cleaners may cause
bicarbonate lenses to become ‘hazy’ or
‘foggy.’
•
Do not use a pressure washer to clean
headlights.
•
Inspect and operate the lights regularly to
confirm proper operation and mounting
condition.
Headlight Moisture
Your coach is equipped with composite
headlights which contain replaceable halogen
‘bulb’ elements, common to most current
automobiles. This type of lamp assembly is not
sealed from the atmosphere and is designed with
a moisture venting system.
Because they are not sealed, under ‘dew point’
conditions the headlights may exhibit signs of
humidity condensation on the reflector surface
and lens, such as small droplets of water or
‘fogging over’.
If this happens, drive with the headlights on so
the moisture can evaporate and expel through the
venting system designed into the headlamp
assembly.
PLASTIC PARTS - CLEANING
Many parts in your motorhome, such as the
dash, exterior light lenses, and certain exterior
body panels are made of high-impact plastic
materials that can be damaged by wiping with
solvents or improper cleaning products.
Always try cleaning plastic parts with the
mildest cleaners first and work your way up to
stronger cleaning products. Use the following
cautionary lists as a guide when selecting
cleaning products to use on plastic parts.