SECTION 7 –
PLUMBING
7-12
Dumping Holding Tanks
(Model 70KL)
1. Remove sewage drain hose from storage
compartment (located on left sidewall).
2. Remove dust cap from sewage drain outlet
and connect sewage drain hose. Be sure it is
firmly attached.
3. Place the outlet end of sewage drain hose into
disposal opening.
4. Open the Black Waste Tank Drain valve with
a quick pull and make sure there are no sags in
the hose. Move the hose gently about to
dislodge any waste and ensure complete
drainage. Close Black Waste Tank Drain
valve as soon as tank is empty.
NOTE: DO NOT OPEN BOTH VALVES AT
ONCE. Do not open the Gray Waste Tank
Drain valve until the black tank is
drained and dump valve closed to avoid
sewage back-up into gray tank. Gray
water also rinses any black water solids
from the sewage drain hose.
5. Open the Gray Waste Tank Drain valve. Be
sure there are no sags in the hose to ensure
complete drainage. Close Gray Waste Tank
Drain valve as soon as tank is empty.
6. Add an odor control chemical to the sewage
holding tank through the toilet. These
chemicals are available at most RV stores.
7. Rinse sewage drain hose thoroughly with
water before stowing.
NOTE: We recommend that you dump all
holding tanks before traveling to avoid
carrying unnecessary weight.
Flushing Your Black Waste Holding
Tank
The black waste holding tank is equipped with
an internal spray head that allows you to rinse the
inside of the tank with a shower of clean water
after dumping.
Sewage Drain Hose
(Located on driver side front of rear wheel)
-Typical View
Sewage Drain Outlet
(Located beneath motorhome)
*Model 70KL
•
1st
- Pull Black Waste Tank Drain
valve to drain black water
(sewage) tank, then close.
•
2nd
- Pull Gray Waste Tank
Drain valve to drain gray water
(sink/shower), then close.
*Model 70KL
