7-3
SECTION 7 –
PLUMBING
Water Pump Switch
The Water Pump switch is located on the
monitor panel (an additional switch is located
near the exterior shower/wash station for your
convenience).
While the switch is “ON”, the pump will
automatically supply water as it is needed.
Do not leave the pump on while away from
your motorhome or while driving.
In time, a
slow leak in a faucet could drain the water tank,
fill the holding tank, and discharge the house
batteries.
Initial Waterline Priming
1. Ensure that all water drain valves are closed,
including water heater valve.
2. Turn Water Pump switch to “OFF” position.
3. Fill water tank.
4. Open all faucets, hot and cold.
5. Turn ON the Water Pump switch.
6. Close each faucet as it begins to deliver a
steady stream of water (close cold water first).
Leave hot water faucets on until they also
deliver a steady stream of water. This will
ensure that the water heater is filled with
water.
7. Check to ensure the Water Pump stops soon
after all faucets have been closed.
8. The Water Pump is now ready for automatic
operation. The pump will start when a faucet
is opened and stop when the faucet is closed.
Further Information
Refer to the Water Pump manufacturer’s
operation, care, and maintenance information
provided in your InfoCase.
COLD WATER FILTER
–If Equipped
To obtain filtered cold water for drinking or
cooking, simply open the galley sink cold water
faucet.
NOTE: Only the galley cold water faucet is
filtered.
The cold waterline flows through an activated
carbon filter that removes chlorine and odors for
taste-free drinking water.
Water Pump
•
Model 70BL: Located beneath galley.
Remove drawers to access.
•
Model 70KL: Located beneath right bed
cabinet.
*Model 70KL shown
