![background image](http://html1.mh-extra.com/html/winnebago/2013-adventurer/2013-adventurer_operators-manual_987453030.webp)
SECTION 3 –
DRIVING YOUR MOTOR HOME
3-8
SIGNAL LEVER/HEADLIGHT
HIGH-LOW BEAM
The signal lever controls the turn signals and
headlight high/low beams.
•
Move multi-function lever upward for right
turn signal and downward for left turn signal.
An audible chime will alert you when the
signals are flashing.
•
Pull end of handle toward you to switch
headlight high/low beams.
Further Information
See your chassis manual for further operating
instructions and features.
MAP LIGHT SWITCH
Turn the driver side Map Light on using the
light dimmer wheel (located on dash). Roll it up
to maximum position until you feel it click into
the Map Light “On” position.
Further Information
Refer to the chassis manual provided in your
InfoCase for more information on the driver side
Map Light switch.
BATTERY BOOST SWITCH
The Battery Boost switch can be used to draw
emergency starting power from the house
batteries to start the engine if the chassis battery
is discharged.
Press and Hold the Battery Boost switch in the
ON position while turning ignition key for
emergency starting power.
NOTE: The House/Coach Battery Disconnect
switch near the entrance door must be
ON and house batteries must be
sufficiently charged for this feature to
work.
Turn Signals/High-Low Beams
(Typical View - your coach may differ
depending on model)
Driver Side Map Light Switch
(Located on dash)
• Roll light dimmer wheel upward fully to
turn driver side Map Light on
Passenger Side Map Light Switch
(Located on passenger side
trim panel)
• Press switch UP to turn on
• Press switch DOWN to turn off