25
Chapter 2: Getting Started
3.1 Cable Mounting Considerations
For a nice look and safe installation, make sure cables are neatly hidden behind the Panel PC.
Refer to
for the cable installation instruction.
Warning!/ Avertissement!
Observe all local installation requirements for connection cable type and
protection level.
Suivre tous les règlements locaux d’installations, de câblage et niveaux de
protection.
Warning!/ Avertissement!
Turn off the device and disconnect other peripherals before installation.
Éteindre l’appareil et débrancher tous les périphériques avant l’installation.
Warning!/ Avertissement!
Follow mounting instructions and use recommended mounting hardware to
avoid the risk of injury.
Suivez les instructions de montage et d'utilisation recommandé le matériel de
montage pour éviter le risque de blessure.
3.2 Safety Precautions
Observe the following common safety precautions before installing the equipment:
•
Use separate, non-intersecting paths to route power and networking wires. If power wiring and
device wiring paths must be crossed make sure the wires are perpendicular at the intersection
point.
•
Keep the wires separated according to the interface. Do not bundle input wiring with output
wiring. Keep them separate.
•
When necessary, it is strongly advised to label wiring to all devices in the system.
3.3 Mounting Guide
The device comes with different mounting options suitable for most of the industrial and
commercial applications. There are two main mounting approaches - Vehicle Mounting (Dash/
Yoke Mounting) and VESA Wall Mounting; both approaches are very easy for user to set up the
Panel PC.
IMPORTANT:
Perform mounting after you establish all the necessary connections. Refer to
for wiring requirements and instructions.
Alternating Current !/ Mise a le Terre!
To prevent electrical shock, the Safety Ground location on the rear must be
bonded to the local earth ground through a minimum 12 AWG wire as short as
possible
Pour éviter les chocs électriques, l
’emplacement de la prise terre à l’arrière
doit être lié à terre locale, à travers un 12 AWG minimum et aussi court que
possible.
