22
8.4~15"G-WIN Military Panel PC (Bay Trail N2930) User Manual
2.5 Connectors
2.5.1 Wiring Requirements
The following common safety precautions should be observed before installing any electronic
device:
•
Strive to use separate, non-intersecting paths to route power and networking wires. If
power wiring and device wiring paths must cross make sure the wires are perpendicular
at the intersection point.
•
Keep the wires separated according to interface. The rule of thumb is that wiring that
shares similar electrical characteristics may be bundled together.
•
Do not bundle input wiring with output wiring. Keep them separate.
•
When necessary, it is strongly advised that you label wiring to all devices in the system.
Safety Precautions:
•
Do not run signal or communication wiring and power wiring in the
same conduit. To avoid interference, wires with different signal
characteristics (i.e., different interfaces) should be routed separately.
•
Be sure to disconnect the power cord before installing and/or wiring
your device.
•
Verify the maximum possible current for each wire gauge, especially
for the power cords. Observe all electrical codes dictating the
maximum current allowable for each wire gauge.
•
If the current goes above the maximum ratings (80 W), the wiring
could overheat, causing serious damage to your equipment.
•
Be careful when handling the unit. When the unit is plugged in, the
internal components generate a lot of heat which may lead the outer
casing too hot to touch.
2.5.2 Connector Description and Pin Assignment
This section contains the description of the G-WIN Panel PC (Bay Trail) external connectors.
2.5.2.1 Power Input Connector
G-WIN Military Panel PC uses military grade lockable connector (MS27467T9F98S for power input
and accepts voltage 12V DC (Optional9-36V DC).
2.5.2.2 Serial Interface (RS-232/422/485)
Use RS-232/422/485serial port connector to connect your Panel PC to external devices such as
mouse, modem or printer.
Pin
№
RS232
RS422
RS485
1
DCD
TxD-
D-
2
RXD
TxD+
D+
3
TXD
RxD+
NC
4
DTR
RxD-
NC
5
GND
GND
GND
6
DSR
NC
NC
7
RTS
NC
NC
8
CTS
NC
NC
9
RI
NC
NC
