WinGD WARTSILA RT-flex58T-D, Maintenance Manual

Page: 78 / 498

Maintenance
0380 − 1/A1
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
6/ 8
Group Component Work to be carried out Intervals
6708 − 1 Water separator − Check condensate collector through sight glass
(see Operating Manual 8345 − 1)
daily
− Check condensate collector for free passage
(see Operating Manual 8345 − 1)
1500 − 3000 Op. h
− Check water separator elements (if necessary
clean them)
1500 − 3000 Op. h
− Remove water separator for general overhaul as required
7
7218 − 1 Lubricating pump
and accumulator
(Pulse lubrication)
− General maintenance works according to instructions
of equipment
manufacturer
− Checking gas (nitrogen) pre-charge pressure:
CLU4 − C min. 30 bar / max. 35 bar
directly after installation of a new accumulator − >
then at least once in first week after start-up − >
afterwards − >
every three months
8
8135 − 1 Exhaust Waste
Gate (LLT)
− During a longer operation period at low engine
load, manually open butterfly valve at least once
per week (see Operating Manual 8135 − 1)
− General inspection according to instruction
of valve manufacturer
Servo oil
automatic filter
− Follow manufacturer’s instructions
Starting air
piping
− Drain (de-water) before and after every
manoeuvering period
Pressure gauges
and pyrometers
− Compare and calibrate according to master
instruments
6000 − 8000 Op.h
Fuel and
lubricating oil
filters
− Clean or replace filter elements
(depending on make, follow manufacturer’s in-
structions)
as required
Pipe holders − Check fastenings periodically, if necessary
retighten screws
(first time after 100 Op.h, then half yearly)
as required
8447 − 1 HP servo oil pipe − Regrind sealing faces as required
8460 − 1 Hydraulic pipe for
exhaust valve
drive
− Regrind sealing faces as required
2013 / V2
Inspection and Overhaul Intervals (Guidelines)