Installation Procedure
WiN7200 Installation and Setup Guide
16
3
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
P
P
r
r
o
o
c
c
e
e
d
d
u
u
r
r
e
e
3.1
Pre-Installation Safety Instructions
Warning!
Before installing the Pico BST, review the following safety hazards:
•
Installing Pico BST can pose a serious hazard. Be sure to take precautions to avoid the
following:
•
Exposure to high voltage lines during installation
•
Falling when working at heights or with ladders
•
Injuries from dropping tools
•
Contact with AC wiring (power system connection)
3.2
Unpacking
Upon receiving the Pico BST unit, perform the following:
1. Examine the shipping container for damage before unpacking the unit.
2. Perform a visual inspection to reveal any physical damage to the equipment.
Note: In case of damage, contact the shipping company.
3. Verify that all of the equipment (listed below) is included. Otherwise contact WiNetworks.
4. The Pico BST is shipped with the following equipment:
•
WiN7200 Pico Base Station (pBST).
•
Integral 2 x omni-directional antennas (optional 65
0
or 90
0
single sector dual slant
antenna including 2 x 1m antenna cables)
•
Data adaptor including Power Supply.
•
Internal GPS receiver and integrated GPS antenna (optional External GPS antenna with
15m cable)
•
pBST pole/wall mounting bracket.
•
Cat5 Serial cable (2m) for the console connector of the pBST (cable connectors: DB9F,
RJ45)
Note: The connection between the pBST to the data adaptor is performed by a standard
outdoor Cat5 Ethernet cable. The Ethernet cable is not supplied.
•
Metal bands x 2 for mounting on poles
•
Screws, springs and washers x 4
