If installing in
hot weather,
increase these
dimensions 3 mm.
Fray braid back as far
as outer cover will
allow.
Trim braid close to
outer cover, and
remove 6 mm of inner
insulation, being careful
not to nick the center
conductor. Make sure
no foil or braid can
touch center conductor.
Slide connector tip
between braid and
inner insulation (braid
and foil, on foil shield
cable). Push connector
on cable as far as it
will go. Attach cable
with proper crimping or
compression tool. Do
not crush cable out-ofn
round.
Connect the coax to the coax
connection port, and tighten until
fingertight. Then, tighten ¼ turn
more.
Make sure that the other end of the coax cable leads to the wall plate/
power supply.
10
Turning on Power Supply
Operation
Raising Antenna
Turn the elevating crank clockwise in
“UP”
direction about 13 turns or until some
resistance to turning is noted.
Turn power supply on to use either front or
rear output of the TV outlet. Neither outlet will
work unless the power supply switch is on.
NOTE
1
2
Rotating Antenna for Best Picture
Lowering Antenna to Travel Position
Make sure the antenna is in the
“UP”/
deployed position. Pull down with both hands
to disengage ceiling plate.
For analog signals,
rotate for best picture. For digital signals,
run a channel scan to find the best signal.
Rotate the antenna until the pointer on the directional handle aligns with
the pointer on the ceiling plate. Turn elevating crank counterclockwise
in
the
“DOWN”
direction about 13 turns or until some resistance is noted. The
antenna is now in the travel position.
3
4
Antenna reception may vary based on transmitting antenna tower height, lobe pattern of the
NOTE
transmitter, height of the receiving antenna, weather conditions and terrain on receiving path
including trees, buildings and hills.
OFF
On/Off Button
Ceiling
Plate
9
Upper
element
housing
Boom
Coax
connection
port
ON
This unit is equipped with a
polyswitch, a current limiting
device, which will shut down +12 VDC if
there is a direct short between the antenna
and power supply. The green indicator light
will not light. Once short is eliminated, the
device will reset itself.
Thread the existing coax cable
between the boom and the center
of the upper element housing.
NOTE
Installing
Connector
on
Coax
Cable
Strip outer cover back
12 mm from end of
cable.
TIP
Lower the antenna to the travel position before traveling!
