Pull the e-clips off of the pins, and
remove the two pins from the
leveling bracket.
Mounting
bracket
2
1
Existing Antenna Assembly
Retrofit
Antenna
Assembly
Leveling
bracket
E-clip
Remove the cap from the coax
connection port. Now, install a
connector on the end of the coax
cable. Refer to the next page for help.
Thread the existing coax cable
between the boom and the center
of the lower element housing.
Continue to thread the coax in an
S-curve. Thread the coax over and
then under the boom.
Replacing
a
Winegard
Sensar
Antenna
with
the
Sensar
HV
Retrofit
Kit
Mounting
bracket
Pin
Coax
Connection
Port
Insert the pin through the leveling
bracket and the elevating gear. Push
the e-clip over the end of the pin.
Using a wrench, loosen and
remove the coax cable from the
coax connection port shown here.
Cut the connector off the end of the
cable, and pull the cable out of the
Sensar antenna. Due to variations
in connector types and cable sizes,
a coax connector is not included.
3
Remove the existing Sensar antenna assembly from the mounting bracket.
4
Elevating gear
Boom
Using the retrofit antenna assembly, insert the elevating gear in-between the
sides of the leveling bracket. The elements should be on top of the boom. The
holes in the sides of the leveling bracket and in the elevating gear should align.
Cap
5
6
7
8
Lower
elemen
t
housing
