6
Installation
1. Connect coax
cables and
power wire to RV pre-
wire harness. Connect gray coax to pre-wire coax for
primary receiver. Connect white coax to pre-wire coax
for secondary receiver. Connect power cable to pre-
wire power cable. See Figure 2.
2. Place cable-entry plate over hole and cables.
Screw in place. Seal plate and screw holes with ap-
proved sealant (not included).
Cable entry installation —
INSTALLING THE POWER SWITCH
1. Choose a location to install the RoadTrip power
ON/OFF switch. Remember when selecting a location
that you will need to run the +12VDC power cable
from the RoadTrip to the switch.
Be sure the
switch is in the OFF position before continuing.
See Figure 7 page 9.
Wall or panel mount
: Drill 1-1/4” hole, pull wires
through wall or panel.
2. Connect the ground wire from the vehicle and the
BLACK ground wire from the RoadTrip together,
using large yellow flag connector.
3. Connect the YELLOW flag connector to
the silver spade on the switch.
4. Connect the RED wire from the RoadTrip to the
small RED flag connector.
5. Connect small RED flag connector to center
spade on switch.
6. Connect the +12 V power wire from the vehicle to
a small RED flag connector.
7. Connect small RED flag connect to isolated
spade on switch.
INSTALLING THE POWER SWITCH DIAGRAM
STEPS 2 & 3
TWO GROUND WIRES
1 FROM VEHICLE
1 BLACK WIRE FROM
SATELLITE DISH
STEPS 4 & 5
RED POWER
WIRE FROM
DISH
STEPS 6 &7
+12 V FROM VEHICLE
ON/OFF ROCKER SWITCH
WITH LIGHT
(Shown in OFF position.)
FIGURE 7
10. The GPS antenna is pre-wired and has a 1 meter
cable running through one of the connectors.
Determine location for GPS antenna. It is recom-
mended you place the GPS antenna 3 feet from
dome and away from any other obstruction.
The recommended location for the GPS antenna is
based on having a level location and a clear view of
the sky for the best satellite signal acquisition. Do not
secure GPS antenna to roof at this time.
IMPORTANT!
The GPS must be located minimum of
3 feet away from obstructions on roof of vehicle.
An-
tenna must have a clear view of the sky for proper
operation.
GPS installation — (RoadTrip SDi only)
!
NICKS OR CUTS IN WIRING JACKET MAY
CAUSE WATER TO LEAK INTO VEHICLE.
COAX CABLE ROUTING
PRIMARY
RECEIVER
(GRAY WIRE)
MV-3500
ROADTRIP
FIGURE 2
SECONDARY
RECEIVER
(WHITE WIRE)
