Wine Cell'R WC194FGBK, Instruction Manual, Page: 25 / 28

24
1. Pry up the hinge cover (1) and hinge cap (2) using a flat head screwdriver. Using a
Phillips head screwdriver, loosen the hinge screws (3a) and remove the top hinge (4).
You can now lift the door (5) off the bottom hinge and set it off to one side. Be careful
not to lose the washer (11) between the bottom hinge and the door. You will need this
later. Also remove lock hole cap (6) and screws (7) and (8) from the top of the door.
The lock cap can be pried up using a small flat head screwdriver.
2. Using a Phillips head screwdriver, loosen screws (3b) to remove the hinge support rod
(9) at the bottom of the door. Rotate the door 180° so that the top is now the bottom
and vice versa. Attach the bottom hinge support rod (9) to the bottom corner of the
door and attach with screws (3b).
3. Using a flat head screwdriver, pry off the bottom hinge cover (12). Using a Phillips
head screwdriver, loosen and remove screws (3c) and (13) and bottom hinge (10).
4. Move bottom hinge (10) to the opposite side and re-insert all screws (3c) and (8).
Bottom hinge cover (12) should clip back onto the bottom hinge (10).
5. Place the washer (11) over the hinge support rod (9) and place the door back on the
bottom hinge by aligning the hinge support rod (9) with the outer hinge hole on bottom
hinge (10).
6. Re-attach top hinge (4) using screws (3a). Insert lock cap (6), screws (7) and (8), and
clip on hinge cap (2).
Stainless steel doors include a handle centered in the middle of the door. There is no
need to alter the location of the handle.
Glass doors include integrated door pull handles. There is no need to alter the location of
door pull handles.
Figure 3 Figure 4