To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
MAINTENANCE
86039020 VOYAGER E 08/20/07
4-2
VAC SHOE TRACKING
To adjust vac shoe tracking, move eyebolts in
or out to increase or decrease spring force,
respectively, until desired tracking is reached
.
VAC SHOE DOWNPRESSURE
NOTE:Downpressure is factory set and
should not require adjustment.
If adjustment of downpressure is required, turn
nut on top of vac shoe clockwise to increase
downpressure and counterclockwise to
decrease downpressure.
VAC SHOE ANGLE
NOTE: The angle of the vac shoe is factory
set and should not require adjustment.
Periodically inpsect the vac shoe angle by
resting it on a hard flat surface. Use a square
to verify 90° angle between the floor and
veritcal surface of the vac shoe.
If adjustment is required, remove one socket on
each lower arm (from the vac shoe or bracket)
and turn clockwise or counterclockwise to
change the angle to the recommended 90°.
Attach the socket on each arm to its respective
location and recheck the angle using the
square. Repeat if necessary.
VAC SHOE
PIVOT ASM.
VERTICAL
SURFACE
OF VAC
90°
SQUARE
ADJUSTMENT
NUTS. REF.
SOCKET
ARM REF.
VAC SHOE TRACKING
EYEBOLTS (REF.)
SIDE VIEW OF VAC
DOWN
PRESSURE
NUT
VAC SHOE
CABLE ASM.
(REF.)
NOTE: USE 90° TOOL
TO VERIFY THAT VAC
SHOE IS ADJUSTED
CORRECTLY TO 90°
ANGLE.
NOTE: ANGLE
ADJUSTMENT
NUTS FOR VAC
SHOE
NOTE: SPRING ATTACHES
FROM CASTER TO VAC SHOE
BRACKET (BOTH SIDES).