Wincor Nixdorf BA63G, Product Manual

Page: 30 / 37

System connection
GB - 25
System connection
The system is connected via the RS232C (V.24) interface with a voltage supply of +12V
DC.
The following parameters are set as standard:
Transmission rate 9,600 Baud
Parity on
Parity odd
Parameters other than these standard values can also be selected. Wire jumpers must
be soldered onto the display circuitry in order to do so.
Wire jumper In/O ut Parameter
JP1 OUT
IN Parity odd
Parity even
JP2 OUT
IN Parity on
Parity off
JP3 OUT
IN 9,600 Baud
4,800 Baud
JP4 OUT
IN Normal operation
Self-Test
The position of the wire jumpers on the display circuitry is illustrated in the following
diagram. The front plate can be removed by pressing both of the exterior housing clips
underneath the plate. The wire jumpers are then accessible.
Customer display, Jumper position