11
60706-160/I
Page 4
60706-160 REV 3
3117-30
D. The generator mounting area of the trailer bed should be
flat. All four generator mounting pads must rest firmly on the
trailer bed. Install shims if necessary to even out the bed
under the mounting pads, then bolt the generator firmly in
place.
ELECTRICAL CONNECTIONS
CAUTION:
Only qualified electricians should install electrical wiring.
Wiring must conform to all applicable national, state, and local
codes. (Reference: National Fire Protection Association
Manual No. 70, National Electrical Code.)
DANGER: PERSONAL INJURY
IF THE GENERATOR IS TO BE USED AS A STANDBY
POWER SOURCE, A SPECIAL DISCONNECT SWITCH
MUST BE INSTALLED TO SEPARATE THE GENERATOR
AND THE COMMERCIAL POWER LINES. THE
DISCONNECT MUST ISOLATE THE GENERATOR FROM
THE COMMERCIAL POWER LINES AND THE LOAD WHEN
Typical Connection Methods for Generator Power Service
Figure 5
TYPICAL CONNECTION METHODS FOR GENERATOR POWER SERVICE
Summary of Contents for W100PTOS-3
Page 20: ...20 60706 160 I W75PTOS 4 W75PTOS 17 BACK VIEW GENERATOR RECEPTACLE PANELS W85PTOS 18 BACK VIEW...
Page 21: ...21 60706 160 I W85PTOS 3 W100PTOS 3 BACK VIEW W85PTOS 21 BACK VIEW...
Page 22: ...22 60706 160 I W105PTOS 4 W105PTOS 17 BACK VIEW W120PTOS 18 W1065PTOS 18 BACK VIEW...
Page 23: ...23 60706 160 I W145PTOS 4 W145PTOS 17 W150PTOS 3 BACK VIEW...
