12
REV C
OPM-118
CHANGING THE OIL
Refer to the Maintenance Schedule Chart for required oil change
intervals.
1. Start the engine and warm it up, stop the engine and remove the
spark plug wire to prevent it from accidentally being started.
2. This engine has an oil drain valve for your convenience. Attach a
neoprene hose and drain the oil into an approved container.
3. Allow the used oil to drain completely, then reinstall the oil drain
plug and a new washer, and tighten the oil drain plug securely.
Dispose of used motor oil in a manner that is compatible with the
environment. Do not throw it in the trash, pour it in the ground, or pour
it down a drain.
4. With the engine in a level position, fill with the recommended oil
to the upper limit mark on the dipstick.
The Oil Alert system will automatically stop the engine before the
oil level falls below the safe limit.
CAUTION: EQUIPMENT DAMAGE:
Running the engine with a low oil level can cause engine damage. This
type of damage is not covered under warranty.
5. Install the oil filler cap/dipstick and tighten securely.
NOTE:
This engine requires 38.4 ounces (1.2 quarts) of oil if it is
completely drained. Use caution when refilling the engine as some
residual oil may have remained in the engine. Always use the dipstick
when filling the engine with oil to prevent overfilling.
6 . After warming up the engine, recheck the oil level and refill as
necessary to bring it to the proper level.
DUAL ELEMENT AIR FILTER
Check maintenance schedule for recommended service period. Service
more often under dusty conditions.
WARNING: EQUIPMENT DAMAGE
Never start or run the engine with the air filter removed. This will
allow dirt to enter the engine, causing rapid engine wear. This type of
damage is not covered under warranty.
ENGINE CARE
MAINTENANCE SCHEDULE
If major engine service or repair is required, contact an authorized
engine service center. The manufacturer of these engines has
established an excellent world-wide engine service organization.
Engine service is very likely available from a nearby authorized dealer
or distributor. See following table.
CHECKING THE OIL LEVEL
The oil level must always be checked before the engine is started.
Refer to the Lubrication section under Preparing The Unit, in this
manual, for instructions on checking the oil level. Take care to remove
any dirt or debris from around the oil plug before removing. Be sure the
oil level is maintained.
