WIN Enterprises PL-80930, User Manual

Page: 116 / 117

head of stand-off cannot exceed
2.0mm. Each side of chassis is
highly suggested to use 3 of
screws or stand-off for slide
attachment.
Step 4 - At tach the chassis
(outer) member to the rail
Attach the L-shaped bracket rack
to the front mounting flange using
M5 screw & ring from screw kit.
Insert the stag into the upper and
lower square holes on rail from the
back of rail. Push the safety lock
forward to secure the bracket. It is
important to check if the safety
lock is in unlocked position before
mounting the brackets.
Step 5 - Attach the inner slide
member to your chassis
Attach the inner slide member to
your chassis using M4 or M5 * 5
screw from screw kit.
Insert the chassis (inner) member
into the cabinet member as shown
on the drawing. It is important to
check if the ball retainer is in fully
open position before install the
chassis. It might cause
catastrophic damage to the
chassis if ball retainer is not in
fully open position while mounting
the chassis. While you are pushing