WilTec SKD-1 with cord Operation Manual Download Page 2

The information contained in this document is subject to change without prior notice. No part of this
document can be copied or duplicated in another form without

 

the prior written consent of  WilTec

Wildanger Technik GmbH. The WilTec Wildanger Technik GmbH assumes no liability for any errors in
this user manual or the connection diagram.
Although WilTec Wildanger Technik GmbH has made every effort to make sure that this user manual
is complete, accurate and updated, errors cannot always be avoided.  In the event of problems with
this user manual please complete and send this form back to us.

FAX-notification (+

49 2403 55592-15

), 

 
from: ________________________________________
 
Name: 

________________

 

Firm:

_____________________

 

Tel/Fax:

__________________

 

I would like to report the following mistakes: 

 
 
 
 

_______________________________

 

 ____________________________________

 

 

 

Customer Service WilTec Wildanger Technik GmbH 
e-mail: 

[email protected]

Tel: +49 2403 55592-0

Introduction

Thank you for purchasing this quality product.

  To minimize the risk of injury we urge that our

clients take some basic safety precautions when using this device. Please read the operation
instructions carefully and make sure you have understood its content.

Keep these operation instructions safe.

© by WilTec Wildanger Technik GmbH 

Seite 2 

http://www.WilTec.de
http://www.aoyue.eu

  January 2020 Version 7

http://www.teichtip.de

Summary of Contents for SKD-1 with cord








Reviews: