WilTec AF18-2, Operation Manual

Page: 4 / 8

© by WilTec Wildanger Technik GmbH Item 34203 Page 4
http://www.WilTec. de
http://www.aoyue.eu 05 2021 -1
http://www.teichtip.de
•
Never use the compressor in areas with steam, moisture, or near water.
•
Turn off the compressor when you are not using it. Unplug it before repairing, overhauling,
maintaining, cleaning, or replacing parts. Never use the power cord as a handle. Keep the power
cord away from hot objects, oil, and sharp edges. Protect it from breaking. Do not pull out the
power plug by pulling on the power cord.
•
If the compressor is used outdoors, only approved extension cables may be used. Each wire in
the extension cable must have a cross-section of at least 1.5
㎟
.
•
Do not store the compressor with the plug plugged in. Do not allow children or other persons
unable to use this device to play or work with it.
•
Be very careful when working with the compressor. Do not use it when you are tired or under
the influence of alcohol, drugs, or medicine.
•
When starting work, make sure that all screws are firmly tightened.
•
Do not use the compressor if it is damaged. If the compressor makes strange noises, strong
vibrations, or other unusual signs that indicate damage, immediately stop the compressor. Do
not make any structural changes to the compressor. Only have repairs carried out by qualified
specialists and with original spare parts.
Properties
•
Compressor with pressure reducer, condensate drain, and pressure gauge
•
Oil-free, piston compressor, no contaminated air
•
With water filter, pressure setting, and pressure gauge
•
Overheating protection
•
Very low noise level
•
Additional fan for better cooling performance and longer service life
Technical specifications
Type Piston compressor
Power (W)
150 (
⅕
hp)
Rotation speed (rpm) 1450
–1700
Flow rate (
ℓ ⁄
min
) 20
–23
Pressure adjustment range (
㍴
) 0–4
Weight (
㎏
)
4.8
Size (
㎜
)
255×135×170
Suitable nozzle sizes (
㎜
)
0.2
–1.0
Hints to the user
•
The compressor has a ⅛″ outlet (9.51 mm, external thread), which can easily be switched to
¼
″. The matching adaptor is not included in the scope of delivery.
•
When the compressor is connected to the airbrush gun via the hose, it can be connected to the
power supply and switched on.
•
The maximum pressure is displayed via the pressure gauge, the operating pressure can be set
via the pressure regulator.
•
The hose supplied is impermeable to air. With the auto-stop activated (repeated switching on
and off), all screw connections and connections should be sealed with sealing tape.