© by WilTec Wildanger Technik GmbH
Item 61123
Page 9
06 2021
-1
Operation
Switching on/off
Note:
Before you operate the on/off switch, check that the saw blade is firmly seated and that it can
move freely. The clamping screw of the saw blade must be tightened firmly.
1. Connect the plug to the power supply.
2. To start the tool, press the release button and flip the switch.
3. Release the trigger to turn the tool off.
Depth adjustment
1. Loosen the clamp to adjust the cutting depth with the locking lever.
2. Hold the base plate flat against the body of the workpiece and lift the body of the saw until
the blade is at the correct depth.
3. Tighten the depth lock lever.
Note:
For the best cutting results, make sure that the saw blade does not protrude more than 28.5 mm
below the underside of the workpiece.
General cut
1. Check the specifications to ensure the suitability of the workpiece.
2. Insert the correct blade to make sure it is sharp and undamaged.
3. Set the cutting depth.
4. Place the workpiece on a flat surface such as a workbench, table or floor. Use a suitable
pad (scrap material) if you do not want to damage the work surface.
5. Connect to the power supply.
6. Grasp the tool firmly and place its metal base plate on the surface to be cut. Make sure that
the rear half of the base plate protrudes beyond the work surface. Do not force the blade in-
to the material.
7. Switch on the tool and wait a moment for the blade to run at full speed. Then press the re-
lease button and slowly and gently but firmly dip the blade into the material. Then slide the
tool forward along the cutting path.
Attention:
•
Never pull the tool backwards.
•
The tool should be guided along the cut with very little force. Too much force leads to the
user’s fatigue and excessive wear on the blade and tool. Too much force can also cause
the temperature shutdown to be triggered due to higher friction and temperature develop-
ment, which leads to delays.
•
After finishing the cut, lift the tool off the work surface before switching it off. If there is a lot
of dust, leave the device switched on for a few seconds so that the dust can be removed
from the interior of the device.
“Pocket cut”
1. Select a suitable saw blade for hard materials and change it. Adjust the cutting depth, pull
out the mains plug and then place the metal base plate on the work surface. Make sure that
the front marking on the base plate aligns with the starting line.
2. Switch on the tool and wait a moment for the blade to run at full speed. Next, slowly and
gently, but firmly, dip the blade into the material. Then slide the tool forward along the cut-
ting line (Never pull the tool backwards)
3. When the finish line is reached, lift the tool off the work surface before turning it off. If there
is a lot of dust, leave the saw on for some few seconds to allow the dust to clear from inside
the tool.
