WilTec 61123, Operation Manual

Page: 8 / 12

© by WilTec Wildanger Technik GmbH Item 61123 Page 8
http://www.WilTec.de
http://www.aoyue.eu 06 2021 -1
http://www.teichtip.de
Accessory list (Fig. 1 and Fig. 2)
Figure 2
№ Name № Name
A Universal (TCT) saw blade D HSS saw blade
B Dust extraction hose E Guide rail
C Diamond saw blade F Hexagon key
Assembly
Check the tool or accessories for transport damage. Take some time to read these instructions care-
fully and to understand all of the contents before installation and operation.
Attention! Before installation, always ensure that the device is switched off and disconnected from the
power supply.
Blade change
1. Lay the saw on the side of a flat surface.
2. Turn the saw blade by hand while pressing the spindle lock button until the blade is locked
and turn the clamping screw clockwise with the hexagon key.
3. Remove the saw blade clamping screw, the outer flange and the washer.
4. Press the release button, lift the base plate and remove the saw blade.
5. Clean the saw blade flanges and then mount the new saw blade on the spindle, which is di-
rected towards the inner flange.
6. Make sure the saw teeth and arrow on the blade are pointing in the same direction (clock-
wise).
7. Fit the outer flange and the washer and re-tighten the saw blade clamping screw.
8. Make sure that the saw blade can run freely by turning the saw blade by hand.
Adjusting the parallel cut guide
1. Release the edge guide locking lever.
2. Slide the edge guide through the slots in the saw shoe to the desired width.
3. Tighten the set screw to secure it in place.
4. Make sure that the edge guide lies against the wood over the entire length in order to
achieve an even parallel cut.