https://www.naturewater.eu
Item 52365
Page 6
11 2022-1
Inverting function of the control panel
The side labelled IN of the automatic sediment filter must be the inlet. You can open the upper cover of
the filter to determine the correct installation position of the inlet and outlet with the help of the IN and
OUT symbols. Depending on the installation conditions and the different position of the inlet and outlet,
the control panel can be inverted as shown.
1.
To do so, remove the upper cover of the lid
of the housing.
2.
Use a screwdriver to untighten the two
screws of the control panel.
3.
Lift the entire control panel and turn it by
180°. While doing so, make sure not to dam-
age the connection valve and electric cable
attached to the card.
4.
Fix the control panel at the corresponding
position in the opposite direction and re-
tighten the two screws.
5.
Re-place the lid onto the valve and screw it
tight.
1
Remove the two screws to turn the control
panel.
Bracket
Included in the scope of delivery, there are a metal
bracket and two brass connection pieces with that
you attach the filter to the pipe. You can fix the filter
to a wall or frame construction (as shown).
Before fixing the filter to the pipe, you should attach
it at the bracket first by using the two brass connect-
ors; only then attach it to the pipe.
Attention!
If using a hard pipe (e.g., PPR or metal
pipe) for the connection, you must fix the filter to the
bracket first; otherwise, the filter cannot be fixed.
1
Bracket
2
Brass connection pieces
