https://www.naturewater.eu
Item 52365
Page 12
11 2022-1
Starting flushing by hand
1.
Make sure that the drain pipe has been fixed and does not have any leakage before commis-
sioning the device.
2.
With the “Work” mode activated, press the LEAN key and pass to the flush mode. “Flush” is
shown on the screen, two “0” signs start to flash.
3.
The device opens the flush valve automatically until flushing has finished. After that, it indicates
the days of flush cycle, e.g., “7,” and, at the same time, the “Work” status is shown.
4.
With the “Flush” mode activated, press the LEAN key. The valve is closed immediately and
flushing stopped.
5.
With the “Flush” mode activated, the SET key is inoperable.
6.
However, you can manually start flushing without the automatic flushing function being acti-
vated.
№
Explanation
1
Press LEAN key.
2
With the “Flush” mode activated, press the LEAN key again to stop flushing and return to the
“Work” mode.
3
Two “0” begin to flash.
Setting of days and seconds
1.
Adjust the days of flushing cycle.
Press the SET key for more than 2 s. When the “Set” mode is shown, disengage the key. The
“Set” mode is activated, the days of flushing cycle are shown.
2.
Press the SET key once shortly to increase the day value by 1. After the day value has been
increased to 30, the value will return to 0. With the value set to 0, the automatic flushing function
is deactivated; however, you can press the LEAN key to start flushing by hand.
3.
When the screen shows the day value, wait for 10
s (do not press any other key) until the “Work”
mode is shown; it is at that moment that the days of flushing cycle are saved.
4.
If you do not wish to wait for 10 s, press the LEAN key to save the days of flushing cycle; at
the same time, the flushing seconds are shown, e.g., “60 sec.”
5.
Press the SET key once shortly to increase the seconds value by 1 (1–99).
6.
After then flushing seconds have been set, wait for 10
s (do not press any other key) until the
“Work” mode is shown. It is at that moment that the flushing seconds are saved; at the same
time, the days of flushing cycle are shown, e.g., “8.”
7.
When you press the LEAN key in the second setting mode, the days setting mode is activated
and, at the same time, the flushing seconds are saved.
SET
LEAN
Automatic Flush Filter
Work
Day
Flush
Flush
SET
LEAN
Work
Automatic Flush Filter