7
Need help?
www.WilsonElectronics.com
Tech Support
877-594-5766
Mon.- Fri. Hours: 7 am to 6 pm MST
Signal Booster Specifications
Mobile 3G
Model Number
460002
Connectors
SMA
Impedance (input/output)
50 ohms
Dimensions
6.2 x 3.6 x 1.3 inch or 15.7 x 9.1 x 3.3 cm
Weight
1 .2 lbs or 0 .54 kg
Frequency
824-894 MHz / 1850-1990 MHz
Power output for single cell phone (dBm)
800 MHz
1900 MHz
Uplink
23 .4
23 .4
Downlink
-3 .1
-0.9
Noise Figure (typical)
3 dB nominal
Isolation
> 90 dB
Power Requirements
Signal Booster Usage
6 V, 0 .5 A - 1 .5 A (subject to uplink power)
Each Signal Booster is individually tested and factory set to ensure FCC compliance . The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware . The Signal Booster will amplify, but not alter the incoming and outgoing signals in order to increase
coverage of authorized frequency bands only . If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected . If
a detected signal is too high in a frequency band, or if the Signal Booster detects and oscillation, the Signal Booster will automatically turn the
power off on that band . For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute .
After 5 (five) such restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily
removing the power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster’s microprocessor.
