4
Need help?
www.WilsonElectronics.com
Tech Support
877-594-5766
Mon.- Fri. Hours: 7 am to 6 pm MST
The Outside Antenna must be
installed vertically on a metallic
surface .
2 . Run the Outside Antenna cable into
the car . The cable is strong enough
that it may be shut in most vehicle
doors without damaging the cable .
For a cleaner look, carefully pull down
the door seal, run the cable under
the seal, and push the seal back into
place . This method reduces wear
on the cable as the door opens and
closes .
3. Install the Low-Profile Inside Antenna.
• Identify a place on the right side of
the driver’s seat to mount the Inside
Antenna . The location should be at
least 18 inches but no more than
36 inches from where the cellular
device will be used .
• Install the Inside Antenna at the
same angle as the cell phone when
held in use or near the laptop’s
cellular data card to maximize signal
strength .
For a more professional look, you
can install the Inside Antenna
underneath a car seat cover or
upholstery .
• When you have tested the
functionality of your Mobile 3G
Signal Booster, mount the Inside
Antenna by peeling off the backing
of the Velcro
®
and attach it to your
selected location on the seat and
secure the Inside Antenna .
4 . Place and connect the Mobile 3G
Signal Booster .
• Select a location for the Signal
Booster that is free from excessive
heat, direct sunlight and moisture
and that has proper ventilation .
Good locations include underneath
a seat or under the dashboard .
• Connect the wire from the Outside
Antenna to the port labeled “Outside
Antenna” on the Signal Booster .
From Inside
Antenna
From Outside
Antenna
From Power Adapter
• Connect the wire from the Inside
Antenna to the port labeled “Inside
Antenna” on the Signal Booster .
• Plug the power adapter into
vehicle’s 12V DC power supply
and attach the cord to the side of
Power Booster labeled “Power .”
NOTE: Do NOT connect the power
to the Signal Booster until you have
connected both the Inside and
Outside Antennas .
• Power up your Signal Booster by
flipping the switch on the back of
the DC power adapter on . A red
light should appear on the power
adapter .
Note: The Mobile 3G Signal Booster
may remain on, in vehicles whose 12V
DC power sources do not automatically
shutdown when the vehicle is turned
off . This could result in discharging the
vehicles battery in one to two days .
Note: Some 12V DC power sources are
shut down when the vehicle ignition is
turned to off . Refer to your vehicle owners
manual for specifics related to your
vehicle .
Note: The aluminum casing of your Signal
Booster will adjust to the temperature of its
environment, but is designed to protect the
