3301 East Deseret Drive, St. George UT 84790
For additional Technical Support visit
www.wilsonelectronics.com
Phone: 866-294-1660 Fax: 435-656-2432
Part #103010 AIG MAR 009 / 01.30.07
Wilson
®
Electronics, Inc.
Antenna Specifi cations
Part Number
301130
Frequency Range
806-894 MHz / 1850-1990 MHz
Impedance
50 ohms
Antenna Gain
5.12 dBi 806-894 MHz / 6.12 dBi 1850-1990 MHz
Radiation
Omni
Polarization
Vertical
Wavelength
0.9 Wavelength 806-894 MHz / 1.95 Wavelength 1850-1990 MHz
Ground Plane
Built-in Ground Plane
Connector
FME Female
Material
Whip - Stainless Steel / Casing - Fiberglass
Coax Cable
RG58 - 7 inches
Height
21 inches / 53.3 cm
Mount
Standard 1-inch x 14 thread
Assembling and Attaching the Antenna
Screw the six radials into the holes near the base of the
antenna (see diagram). Note: The hole size is different
between the short and long radials. Tighten the radials
snugly with a wrench. Do NOT over tighten. The included
liquid thread lock must be used to ensure the radials do
not vibrate loose.
Use the 1” 14-thread coupler (included) to attach the
antenna to any standard marine mounting bracket.
The coupler provides a feed through for routing the
connecting cable, which will run to your cell phone,
cellular data card, or Wilson signal amplifi er.
Once the antenna is properly attached to the mounting
bracket, attach the connecting cable (sold separately)
to the antenna’s 7” pigtail cable and route it to the
location of your cell phone or cellular data card. Use the
appropriate adapter for your cell phone or data card (sold
separately). If you are using a Wilson Signal Amplifi er,
carefully follow the instructions included with the model
purchased.
Warning:
Damage will occur to the cable
when the antenna is attached to the coupler if the
cable is not allowed to turn freely.
!
7” Coax
Cable
Antenna
Base
Coupler
