Installation and operating instructions Wilo-Control IF-module LON / IF-module Stratos LON
70
English
Object major version
network output config unsigned short nciObjMajVer
This output configuration network variable provides the high byte for the
software version.
SCPT reference: SCPTobjMajVer (167)
Object minor version
network output config unsigned short nciObjMinVer
This output configuration network variable provides the low byte for the
software version.
SCPT reference: SCPTobjMinVer (168)
7 Installation and electrical connection
The installation and electrical connections should be performed only by
skilled staff in compliance with local regulations!
WARNING! Danger of injury!
The existing accident prevention regulations should be observed.
WARNING!
Danger from electric shock!
Any hazards from electrical current should be ruled out.
Any local or general directives [e.g. IEC, VDE etc.] and directives of the local
power supply companies should be observed.
7.1 Installation and electrical connection of the IF-module
NOTE: The IF-module LON is equipped with a Neuron ID double sticker.
One sticker remains on the IF-module, the other sticker can, for example,
be stuck on the system plan in the position of the corresponding pump.
The Neuron ID from the system plan can be read in with a barcode scanner
or entered manually during binding.
CAUTION! Risk of damage to the IF-module!
The IF-module LON may only be conneceted or disconneceted if the pump is
electrically isolated.
• Electrically isolate the pump.
• Remove the terminal box cover after undoing the screws.
• Connect the IF-module to the circuit board interface:
• Stratos/-D/-Z/-ZD
Fig. 3a
• IP-E/DP-E, ...
Fig. 3b
• IL-E/DL-E, ...
Fig. 3c
• For pump types that are not represented here:
See the installation and operating instructions for the respective pump.
NOTE: In order to adhere to the EMC standards specified in the installation and
operating instructions for the Stratos series, a shielded cable should be used to
connect the LON interface.
