- 5 of 14 -
1.
Starting
Only well instructed persons should start and work with the heater.
Before starting the heater check for obvious defaults, proper setting up and as well the
electr. supply.
a)
Ensure a stable set up of the heater.
b)
Fill the tank with clean Heizöl EL (Diesel).
c)
Install exhaust system according to the drawing, see page 10.
d)
Power supply: Connect heater to the 230 V - 50 Hz power supply.
e)
Put room thermostat on suitable place in the room and set to desired
temperature. (Must be above ambient temperature).
A T T E N T I O N
The heater is standard equipped with a fuel preheating device. The function of the
preheating is only given if the heater remains on stand-by with plugged-in electrical
plug for appr. 15-20 min. before the first starting.
During this time the oil is preheated so that the sorting out of paraffine is avoided.
During service always obbey the surface temperature from the fuel preheating device.
Disconnect the heater first from the power supply and let it cool down (danger of
burning).
Operation "Heating without room thermostat"
Set main switch to position "1".
The automatic heating operation is started when the switch is set to position "1".
The heaters works continuously, the delivered blind plug must be connected with the
thermostat socket.
Operation "Heating with room thermostat"
The heater works automatically and depends on the temperature. Remove the blind
plug, connect the plug of the room thermostat with the thermostat socket. Adjust
required temperature on the room thermostat, turn again main switch to position "1".
Set room thermostat to desired temperature.
Operation with warm air hose
The device can be operated with a warm air hose (max. length 7.60 m). This is only to
be used in connection with a hose adapter. It is essential to ensure proper installation;
reducing the diameter can lead to overheating and shutdown of the device (safety
thermostat)!
