Rev. 9/2021
Installation & Operation Manual
AquaFount
®
Washfountain
WAF-4400 Series
Willoughby Industries, Inc.
TOLL FREE
(800) 428-4065
● LOCAL
(317) 875-0830
● FAX
(317) 875-0837
Page 13
www.willoughby-ind.com
Installation Instructions (cont.)
Step 3: Head and Basin Assembly*
Parts supplied:
• Solid surface wash basin
• Pedestal base assembly
• Actuator housing assembly
• 1/4-20 x 1/2" security screws
• 1/4-20 tinnerman nuts
Caution: Do not leave bowl on the pedestal unsupported, as it may fall and cause
damage or personal injury.
*For details on the following instructions, see
WAF-4400 Assembly Drawing
on Page 14
1�) With the help of an assistant, carefully lift wash basin onto pedestal base� Line up the 2 front
brass threaded inserts on the basin with the 2 holes on the forward top of the pedestal, secure
with (2) 1/2" security screws.
Do not fully tighten screws yet.
Note:
BE SURE to use the security screws included with the washfountain. Using longer
security screws than those provided can damage the solid surface basin.
2.) "Sandwich" the basin backsplash between the pedestal top and the holding bracket using
tinnerman nuts and security screws�
3�)
Place the Actuator Housing Assembly on top of the basin; position it so the 2 holes near the
back of the actuator housing assembly line up with the 2 holes of the basin bracket.
Using (2) 1/4-20 x 1/2"security screws, secure in place.
Do not fully tighten screws yet.
5.)
Thread one wing nut on top of each 6" all-thread rod just until the threads come through the
other side; turn over so that the nut is now on the bottom�
5�)
Holding the end with the wing nut with your hand, slide the all-thread rod down through the
large oblong slot in the middle of the actuator housing assembly�
6.) Feed the all-thread rod back up through the 2 holes on the pedestal top panel and
through the corresponding hole in the actuator housing assembly� Secure with second wing
nut� Repeat process for the other hole�
6�)
Attach additional wall anchors (if needed) through the Actuator Housing into the wall�
Step 3: Head and Basin Assembly instructions continue on Page 14