Rev. 9/2021
Installation & Operation Manual
AquaFount
®
Washfountain
WAF-4400 Series
Willoughby Industries, Inc.
TOLL FREE
(800) 428-4065
● LOCAL
(317) 875-0830
● FAX
(317) 875-0837
Page 11
www.willoughby-ind.com
Installation Instructions
Step 1: Pedestal Mounting
Parts supplied:
• Pedestal (pre-assembled)
• Mounting Bracket
Note: Hardware for wall anchoring by others.
1�) Remove plastic protective coating from all stainless parts before installation�
2.) Measure and mark the vertical centerline of the washfountain on the wall. Mark a level line at
the desired height:
Pedestal Bracket (hole center) -25 1/2" A.F.F. for 34" rim height
-23 1/2" A.F.F. for 32" rim height
-21 1/2" A.F.F. for 30" rim height
3.) Place mounting bracket (marked S600282 for 4 station) against the wall and align the middle
mounting holes with vertical centerline marked on the wall.
Make sure that the intended anchor locations will provide adequate backing to support the
installed washfountain. If adequate backing does not exist, install appropriate support backing
or relocate unit before proceeding with installation
(backing provided by others).
4�)
Secure the pedestal to the wall using wall anchors that are adequate for the type of wall: dry
wall, concrete, metal studs, wood studs, etc� (supplied by others)�
5�) Remove solid surface front panel and carefully place out of the way� Place pedestal onto the
mounting bracket with upper channel support resting on the bracket.
Note: Be sure back panel is level and plumb against wall so that water in basin will drain
correctly once assembly is completed.
6�) Secure pedestal to the wall using
all
thru holes for secure mounting�
INSTALLATION INSTRUCTIONS
Visit our website at http.//www.willoughby-ind.com
2210 West Morris Street • P.O. Box 21217 • Indianapolis, IN 46221
(317) 638-2381 • Fax: (317) 638-6110 • (800) 428-4065
© Rev. 11/2007
Page 4
STEP ONE
Pedestal Mounting
Parts supplied:
· Pedestal (pre-assembled)
Mounting Bracket
Note: Hardware for wall anchoring by others.
1.) Remove plastic protective coating from all stainless parts before installation.
2.) Measure and mark the vertical centerline of the washfountain on the wall. Mark a level line at the
desired height:
Pedestal Bracket (hole center)
-25 1/2" A.F.F. for 34" rim height
-23 1/2” A.F.F. for 32" rim height
-21 1/2” A.F.F. for 30" rim height
3.) Place mounting bracket (marked S600282 for 4 station and S600296 for a 3 station) against the wall
and align the middle mounting holes with vertical centerline marked on wall.
4.) Secure the bracket to wall using wall anchors that are adequate for the type of wall; drywall, concrete,
metal studs, wood studs, etc. (supplied by others).
5.) Remove solid surface front cover and carefully place out of the way. Place pedestal on to mounting
bracket with upper channel support resting on bracket.
Note: Pedestal must me level for fixture to drain properly
6.) Secure pedestal to wall using all thru holes for secure mounting
.
Parts/Materials supplied:
· Solid surface basin
· Drain assembly
1.) Insert drain spud into wash basin using plumbers
putty (supplied by others).
2.) From beneath basin, thread the washers &
locknuts onto the drain spud and secure locknuts
against wash basin.
3.) Secure drain cover using the provided screws.
STEP TWO
Drain Assembly
© Rev. 5/2010
