7
SHELF/SLIDE FITTING
When positioning slides on standard cabinets and
counters, present slide to racking by holding it in
the opposite hand to the side of the cabinet to that
which they are to be applied. Present slide at 45°
angle (figure 1). When in place, let slide drop into
position to create a horizontal ledge on which the
shelves will sit.
The WMP135 models are fitted with pilaster and
clips (figure 2) for fitting.
LOADING / SHELF DISTRIBUTION
Before loading, allow the appliance to reach its
normal operating temperature.
•
Never load beyond capacity.
•
Always store items within shelves.
•
Uniform product temperature is maintained by
air circulation, ensure even loading.
•
Do not place items against the rear plenum or
pushed against side walls.
When loading the appliance, please ensure that its
load is equally distributed throughout and ensure air
can circulate around and through stored products.
Care should be taken when loading the appliance.
Do not obstruct the air ducts. Take care of any parts
with possible sharp edges.
LOCKING FACILITY
On models with a locking facility, it is recommended
that the key be removed from its lock during normal
working use. This will prevent bending or breaking
of the key which could result in the lock having to be
replaced.
Removing the key will also prevent accidental
locking when the door is open. This will prevent the
door from closing properly and cause the interior
temperature to rise. If not checked in time, a loss of
product may result.
FIG 1.
FIG 2.
INSTALLATION
