DL107, DL207 and DL210 2.0 Digi-Loop™ DSP Induction Loop Amplifiers
23
PC APP MAIN SCREEN
A602
Output
Effects
Output
Mute
Input Mute
Input Effects
Custom Input
Name
Custom
Output
Name
Input Trim
or ‘Mic Gain’
Line/
Mic/
Phantom Mic
Select
Input
VU Meter
Mix
Gain
Loop
Mode
Selection
Loop
Output
VU Meters
Overload
Indicator
Output
VU Meter
Output
Gain
adjust
Amplifier
Status Box
Input Gain
Mix Gain
- Allows an additional point of control to mix individual inputs as required for each output. (Click on the dial, then slide up/down to
adjust)
Line/Mic/Phantom Mic Select
- Switches between a Line-level signal, dynamic microphone or 48 V condenser microphone.*
Input Trim
- Provides fine trim of the input gain.
Caution! It is very important to make sure the appropriate input configuration is set BEFORE plugging
the source into the Input 1 or Input 2 jacks.
Digital In Switch
- Switches “Digital In L” and “Digital In R” (inputs follow each other) to either Dante or AES/EBU.
Input Effects/Output Effects
- Opens the Input or Output Effects adjustment window.
Input/Output Mute
- Mutes the Input or Output without the need to use the slider control. Unmute returns to slider gain level.
Input VU Meter/Output VU Meter/Loop Output VU Meters
- Shows the active level of the audio post-adjustment.
Input/Output Gain
- Gain adjustment slider control.
Custom Input/Output Name
- Provides the ability for a custom name. The jack label is preserved above the custom name.
Loop Modes
- Changes the internal configuration of the amplifier to drive the load(s) chosen.
Input/Output Overload Indicators
- This light will turn red once an overload condition is reached. It remains red until cleared. Clear the
overload indicator by clicking on it.
Status Message Area
- If the amplifier encounters error conditions, a specific message will be displayed in this area, i.e. if a loop is open.
