PAGE 33 OF 98
NIGHT SCAN POWERLITE, POWERLITE XTREME, AND POWERLITE HDT
OPERATING INSTRUCTIONS
TP-4723701-U
MAY 2021
If the unit was provided with an optional on-board air compressor (replacing the air valve
assembly), only the exhaust hose need be connected. The exhaust hose must be routed to a
location where it will not expel air or water onto personnel or equipment sensitive to moisture.
Figure 5-4 Air Supply Connections
5.6 Installing Remote Control
This section provides information to install the remote control. Several options are available.
Follow the instructions appropriate for your system.
5.6.1
Wired Hand Held Remote Control (HHRC)
Go to section 5.6.2 to if you are installing the Panel Mount Remote Control (PMRC) or section
5.6.3 for the wireless control option. This section will describe how to install the Wired HHRC with
a bulkhead.
The bulkhead connector is provided to remotely install the connection point for the HHRC at the
operator control location. The operator station should be located where the operator has line-of-
sight to the mast operating space. The bulkhead and HHRC should be located in a protected, dry
location (the HHRC is IP54).
To attach the bulkhead:
1. Drill clearance holes for 1/4-20 screws located per Figure 5-5. Either two hole pattern can be
selected according to the space available.
2. Using the screws, washers, and nuts provided, attach the bulkhead to the vehicle. Torque the
1/4-20 screws to 62-70 in.-lb. (7-8 Nm). Alternative M6 stainless steel hardware (not
provided) can be used.
3. Attach the ground wire to the vehicle.
4. Attach the HHRC connector to the bulkhead connector by rotating the lug until it locks in
place.
Air Supply In
Air Exhaust Out
Summary of Contents for Night Scan Powerlite
Page 2: ......
