10.
Reset the restrain lever to open if accidentally tripped
when raising the mast.
11.
Leave cable loose while deploying the mast by
unwinding several feet of cable from the winch with every
tube section deployed.
17
19
12.
Manually load tube sections into the bottom of the
installed top tube, matching the notches on the top tube
with the notches on the top of the next tube in the tripod.
Match dimple profiles if payload alignment is required.
EZ RAZE Deployment
19
18
20
13.
While holding onto the tube that was just loaded,
loosen the lower clamp to the left. Push the tube up until
only a hand’s length is visible, then tighten the clamp to
the right. The manual lifter can also be used to push the
tubes up. Repeat this step until all tubes are loaded.
Tighten tripod clamp to maintain azimuth direction.
Do not duplicate, alter, or copy without the written consent of The Will-Burt Company. © Copyright 2013 The Will-Burt Company
15
www.antennamast.com
