Please have the last 7 digits of your VIN# ready when you call for parts.
Have a problem - Need parts - Please call Toll Free (866) 658-7300 • Email: [email protected]
Check before Riding
• Make sure the brakes work properly and adjust if necessary.
• Check bolts for tightness.
• Make sure there is plenty of fuel.
• Check tire pressure.
• Check all of the lights, headlight, taillight, turn signal etc.
• Check the engine oil.
Starting Off, Riding, Stopping and Parking Before starting,
put the side stand up.
(1).Turn the key to the on position.
(2).Apply the rear brake.
(3).With the throttle at idle position push the electric start button or use the kick
start: if the engine fails to start turn and release the throttle then push the electric
start button or kick start again. Be sure and replace the kick starter to its original
position before riding.
(4).If the bike is on the center stand hold the handle bars with both hands and push
forward, if the bike is on the kick stand hold the bike up and push the kick stand
with your foot.
(5).For a cold engine, let the engine idle for 1-3 minutes before riding.
(6).Sit on the bike keeping one foot on the ground for stability, release the brake and
twist the throttle to accelerate, after you start to accelerate put both feet on the
foot rest only putting them on the ground when coming to a stop.
(7).When coming to a stop decrease your speed by releasing the throttle and
apply both of the brakes, if the front tire begins to skid release and reapply.
(8).Parking: Turn the handlebars to the left as far as they will turn, then turn the
key to the lock position (this will lock the steering, remove the key, to avoid
theft.) Put your kick stand down or use the center stand.
NOTE:
The muffler
and exhaust pipe are hot. Park away from pedestrians.
(9). Practice in an empty parking lot or driveway until you feel confident enough
to ride on the street.
(10). When preparing to ride on a street make sure the headlights are on, check
for traffic and use your turn signals at all times remember to turn the signals
off after use.
(11). Always remember to obey your local and state laws and regulations.
9
Left Handlebar Switches
Dimmer Switch
• When the headlight is in the on position you have two options on the switch:
1. high beam
2.low beam
Turn Signal
• Use the turn signals when turning, pulling over or changing lanes to indicate to the
other motorist which direction you are going. Push the switch to the right to turn
right or push it to the left to turn left. The switch will automatically return to the
center but the light will not go out until you push in on the switch.
Horn Button
Right Handlebar Switches
Light Switch
1. All lights are off.
2. Taillight, licenses plate light
and the dash lights are on.
3. Headlight, taillight, licenses plate light and the dash lights are on.
Electric Start Switch
Turn the key on then push this button to start the bike.
NOTE:
• Make sure all accessory switches are in the off position.
• Apply the rear brake prior to starting the engine.
• Never exceed 4 seconds when using the starter switch.
• Release the starter switch immediately after the engine starts.
• Do not apply the starter switch while the engine is running.
Front and Rear Brake Levers
• The front brake lever is located on the right handlebar and the rear brake lever
is located on the left. Use both brakes when stopping, if the front wheel skids let
off Immediately and reapply.
6
1.
2.
3.
