Main Switches
On Position:
• Electrical circuits are switched on. The engine can be started and the key can
not be removed.
• Do not leave the main switch in the on position for an extended period of time
if the engine is not running
Off Position:
• All electrical circuits are off and the engine is stopped. The key can be
removed in this position.
Steering Lock Position:
• Turn the handlebars to the left as far as they will turn, turn the key to the lock
position and remove.
Please have the last 7 digits of your VIN# ready when you call for parts.
Have a problem - Need parts - Please call Toll Free (866) 658-7300 • Email: [email protected]
Battery
• This scooter uses a sealed lead acid battery, it is unnecessary to check or add
liquid.
NOTE:
Never open the electrolyte of a sealed battery. Remove the battery from
the scooter and store separately in a well ventilated area when the scooter is not
in operation for long periods of time.
Steering Lock
Position
On Position
Off Position
5
General Maintenance
Engine Oil Replacement
• Replace the engine oil after the first 50 miles with 5w50, 10w50 or 15W50
synthetic engine oil. Then replace again every 1,500 miles. Check oil level every
500 miles, add oil if needed.
Changing the Engine Oil
(1).Warm up the engine for a few minutes.
(2).Stop the engine.
(3). Place scooter on center stand.
(4).Place an oil pan under the engine and remove the dipstick.
(5).Remove the drain plug and drain the oil.
(6).Reinstall drain plug.
(7).Fill the engine with oil and install the dipstick. The recommended 5W50 until the
level is in the designated area on the dipstick.
(8).Start the engine and check for oil leaks. If a leak is found stop the engine
immediately and look for cause.
Final Oil Replacement
• Replace the gear oil after the first 500 miles with 5W/50
synthetic engine oil. Replace the gear oil again every 4
months or every 2000 miles.
• Replacing the Gear Oil
(1).Put the scooter on the center stand.
(2).Place an oil pan under the gear case.
(3).Remove the oil filler bolt and the drain plug to drain the oil
(4).Reinstall and tighten the drain plug.
(5).Fill the gear case with oil.
(6).Reinstall the oil filler bolt.
(7).Check for oil leakage.
Cleaning Air Cleaner
Be sure to check the air cleaner regularly.
(1).Place the scooter on the center stand.
(2).Unscrew and remove the left side panel.
(3).Remove the air cleaner cover by removing the screws.
(4).Take out the air cleaner by removing the screws.
(5).Remove the air cleaner element and wash it gently, but thoroughly in solvent.
Replace if damaged.
(6).Squeeze out the excess solvent and dry it.
(7).Apply oil to the entire surface of the air cleaner and squeeze out the excess
oil. It should be damp but not dripping.
(8).Install the air cleaner, cleaner cover, and left side panel.
Spark Plug
A7RTC
Gap .035
10
