28
4.0 Fixing the Appliance - Cable Fixing System.
The appliance can be installed using the wire fixing kit. This type of fixing is shown in the
following picture. The fiBng system comprises four (4) eyebolts, two (2) fixing cables, two (2)
screwed nipples and two (2) adjuster fiBngs.
This installaon requires that the burner tray is removed from the firebox. Remove the screws
securing the burner tray to the firebox (for details see page 42-44) and set the tray aside during
the firebox installaon.
Simply drill and fit the eyebolts then thread the fixing cables through the two small holes at the
top/rear of the appliance, pass each cable through the two holes as shown—this will secure the
cable. Thread the cable through the eyebolts and back into the appliance. When the appliance
is in its installed posion, pull the cables ght and slide the adjusters to the back of the fire—
ensuring the back-nut on the adjuster has been run as far up the thread as possible to the
hexagon shoulder. Keeping the cable ght, fit the screwed nipple to the cable and secure. Turn
the back-nut on the adjuster fixing and the cable will be tensioned unl the appliance is
securely fixed.
The foam seal which is supplied with the appliance should be affixed to the rear face of the
flange. The cable fixing installaon will require the burner tray to be removed—see page 42
INSTALLATION
INSTRUCTIONS
Fixing the
Appliance
