WIKA Obsolete CF1M, Operating Instructions Manual

Page: 4 / 22

Operating Instructions Temperature Indicating Controller CF1M
V1.
1
•
03/200
5
- 4 -
3.1 Operation flow chart
PV/SV display mode
(Approx. 1s)
Control output OFF function
[ ]
Output manipulating value display
(Approx. 3s)
+ + (Approx. 3s) + + (Approx. 3s)
[Main setting mode] [Sub setting mode] [Auxiliary function setting mode 1] [Auxiliary function setting mode 2]
Main setting 1
[ ]
AT Perform/Cancel or
Auto reset Perform
[ / ]
PV/SV display change
[ ]
Sensor selection
[
]
Main setting 2
[
]
Proportional band value setting
[ ] Setting value lock designation
[ ]
PV filter time constant setting
[
]
Integral time setting
[ ] Main setting value high limit
setting [
]
Output high limit setting
[
]
Derivative time setting
[ ] Main setting value low limit
setting [
]
Output low limit setting
[
]
Proportional cycle setting
[ ] Sensor correction setting
[
]
Output ON/OFF hysteresis
setting [
]
Temperature alarm setting
[ ] Instrument number setting
[
]
Event output function selection
[
]
Heater burnout alarm output
setting [ ] Transfer rate setting
[
]
Temperature alarm action
selection [
]
Loop break alarm time setting
[
]
Temperature alarm energized/
deenergized selection [
]
Loop break alarm action span
setting [
]
Temperature alarm hysteresis
setting [
]
Temperature alarm delayed
timer setting [
]
Main setting value rising rate
setting [
]
Main setting value falling rate
setting [
]
Output Direct/Reverse change
[
]
Auto-tuning bias setting
[
]
ƒ + : Press the key while the key is being pressed.
ƒ + (Approx. 3s): Press the key for 3 seconds while the
key is being pressed.
ƒ + + (Approx. 3s): Press the key for 3 seconds while
the and key are being pressed.
The functions with dashed frames are optional
and not active for every controller !