Page 24
Euromat 64
V16-01 9
401-110-001-EN
Carry out the following steps before operating the device:
●
Check the device for obvious defects.
●
Check the mains plug/power cable for obvious defects.
→
Devices with a defective mains plug/power cable must not be put into
operation.
→
Only authorised and trained WIESHEU GmbH service partners
are permitted to repair defective mains plugs/power cables.
●
Check that the door seals tightly.
●
Check that the door locking system functions correctly.
●
Check if there is any dirt, product residue or other contamination lodged
between the door seal and the pane.
→
If necessary, remove it.
●
Check whether the fan cover is installed.
●
The device must not be operated without the fan cover.
●
Check whether the fan cover is correctly inserted and fastened in its
bracket.
●
Check whether the tray frames are suspended correctly in the baking
chamber.
●
Check whether the required power supply is available.
●
Check whether the water tap is open.
Risk of burning!
Otherwise, there is a risk of being scalded by escaping hot liquids when you
open the door.
Each time before carrying out commissioning of the oven, ensure that there is
no water in the oven chamber.
This also applies to the function “Auto-start”.
If there is liquid in the chamber due to an error, you must not commission the
appliance under any circumstances. Disconnect the device from the mains.
To repair the damage, inform an authorised service partner.
The device is equipped with a safety thermostat:
It switches the device off once a temperature below -8 °C or +329 °C is reached
inside the baking chamber. If the ambient temperature is less than -8 °C, you will
not be able to turn on the device.
3.7.1 Inspections to be carried out before commissioning
INFORMATION
WARNING
