Kunststoffschweißtechnik
Operating and indicating elements
Chapter 4
29.03.2011
Working instructions WIDOS RSR 630
Page 17 of 27
4.3. How to adjust the sawing radius
•
In order to adjust the radius, release
both clamping levers.
•
Push the swiveling bow until the desired
radius is shown on the measuring tape.
•
Fix the setting with the both clamping
lever.
4.3.1.
How to adjust the angle for branch pipe 45° and 60°
In case of branch pipes with angle 45° or 60° having to be cut, the prism thus has to be
swiveled upwards.
For this purpose detach the two hexagon-
head screws „1“ in the rear from prism and
support and unscrew the two hexagon-head
screws „2“ in front.
Swivel the prism upwards and mount the
long fixings for angle 45° - branch, the short
fixings for angle 60° between prism and
support and fix the hexagon-head screws„2“
again.
Depending on the pipe size and angle it will
be necessary to shift the prism in order to
minimize the unsupported pipe overhang.
•
For this purpose detach the hexagon-
head screw „3“ and push the support with
the prism to the required position.
Clamping lever
Pointer for reading
Hexagon-head screw „1“
Fixing for 45° / 60°
Support
Prism
Hexagon-head screw „2“
Hexagon-head screw „3“
